![]() Part 4 of 5: Evacuate the system of all moisture Once the bracket has been secured, you can now tighten the accumulator lines for the final time. Step 4: Tighten the lines that connect to the accumulator. Be sure to secure the bracket before tightening the lines for the last time.Īs with the bracket impeding your ability to start the threads, tightening the lines will impede you from aligning the bracket bolt or bolts to the car. Step 3: Secure the accumulator to the car with the accumulator bracket. Securing the accumulator before starting the threads can lead to cross threading. Guide the lines into the accumulator and start the threads before securing the accumulator. Step 2: Install the accumulator and bracket onto the car. Be sure to lubricate the new o-rings to keep it from breaking when installing the accumulator.Īpplying a lubricant also helps to keep the o-ring from drying out, shrinking, and cracking over time. Step 1: Install new rubber o-rings onto the accumulator lines. These will need to be replaced with new ones. Step 3: Remove the old rubber o-rings from the lines. If this is the case, use some spray penetrant and a twisting action to free the accumulator from the lines. Often, the lines get stuck in the accumulator. Step 2: Remove the accumulator from the bracket and the vehicle. The bracket will give you leverage when removing the lines. You want to remove the lines before you remove the accumulator bracket. Step 1: Remove the lines connecting the accumulator to the rest of the A/C system. Be sure to follow the procedure as laid out by the manufacturer of the recovery system you are using. Step 4: Disconnect the recovery machine from the car. This will be about one to four ounces, but it varies depending on the size of the system. You will need to fill the system with the same amount of oil recovered from the system. Step 3: Measure the amount of oil recovered from the system. This will depend on the system you have available to you. Refer to your owner's manual for your specific recovery system instructions. Step 2: Turn on the A/C recovery machine and begin recovery. If it does not depress the schrader valve, you will not be able to service the A/C system. Whichever one you are using, make sure it is depressing the schrader valve of the service port on the car.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |